|
|
|
|
| |
|
|
| |
Managed HPNA Ethernet Bridge
Use Your In-House Phone Lines
Providing You the
Management Home Networking by Existing Wiring
|
|
The HomePNA3.1 Ethernet Bridge, PET-322, Enables You to Set Up
Your Private Network at Home with Your Existing Phone Lines.
No Additional Network Wiring is Necessary. You may just Find a
Phone Jack in the Wall, Plug in the Device,
And Ready to Access the Broadband Internet.
No Extra Utility/Setting is Necessary, just Link Up.
Simply Plug and Play.
Via the RJ-45 Ethernet Ports, Connect to Devices as
Set-Top Box(STB), Camera Server, and Switch/Hub. Up to 128Mbps will
Bring You to Enjoy the Video-On-Demand(VOD) or Multimedia-On-Demand(MOD)Service.
SOHO can Quickly Extend or Flexibly Change the Existing LAN Environment
With No Re-Wiring and No Trouble. |
|
- HPNA Port as Home Network Trunk by Using Existing Phone Lines
- Two 10/100M Ethernet Ports for FTTH, ADSL/Cable Modem, PC, STB
- Distance up to 2000 Feet
- Filter Built-in to Eliminate Noise from Phone Set or PSTN Line
- Remote Web Configuration and Diagnosis
- Recovery from Firmware Upgrade Failure
- Firmware Upgrade for End-Points(EP)
- QoS Priority and Mapping Support
|
|
 Network Standards
- ITU-T G.9954, G.9954.X
- IEEE802.3
- IEEE802.3u
- IEEE802.3x
Connectors
- Ethernet : Two RJ-45 Ports
- HomePNA : Two RJ-11 Ports,
One for HPNA, the Other One for Phone Line By-Pass.
Transmission Power/Spectrum
- -7 +/- 1 dBm, 4~20MHz or 12~28MHz
Transmission Speed/Distance
- Up to 128Mbps (112Mbps for 12~28MHz)
- Up to 2000 Feet
Quality of Service
- Priority based on IEEE802.1p/IP TOS/Diffserv and TCP/UDP Port
- Tag VLAN Pass-Through/Tag/UnTag
- Quaranteed QoS based on HomePNA3.1 Parameterized QoS
Network Management
- Web Configuration and SNMP Support
- Remote Firmware Upgrade
- Recovery from Firmware Upgrade Failure
- Diagnosis of HPNA Interface
- Firmware Upgrade for End-Points(EP)
Fast Ethernet Interface
- 10/100Mbps
- MDI/MDI-X Auto Crossover
DIP Switch
Reset Button
- Reset Device or Force to Factory Setting
Indicators
- "Power" LED
- "LAN1", "LAN2" LEDs for Ethernet
- "Link/Act", "SyncMode", "Diagnosis" LEDs for HPNA
Power Requirement
- External Power Supply : 5V DC
- Power Consumption < 4 Watt
EMI/EMC/Approval
- Comply with FCC Part15, Part68
- Comply with CE
Environmental Conditions
- Operating Temperature : 0ĒJ ~ 40ĒJ (32ĒK ~ 104ĒK)
- Storage Temperature : -10ĒJ ~ 65ĒJ (14ĒK ~ 149ĒK)
- Operating Humidity : 10% ~ 95%, Non-condensing
Physical Dimension
- 160mm (W) x 105mm (D) x 28mm (H)
Unit Weight
|
|
|
|
| |
|
|
|
| |
 |
|
Copyright ©SendTek Corporation. All rights reserved |
|
|
|
