|
|
|
|
| |
|
|
| |
Coax MDU Master Bridge
Use In-Building Coaxial Cable
Manage Your Broadband Service
With Minimal Initial Cost
Last Mile Distribution of FTTB
|
|
The HomePNA3.1 Coax MDU Master, CEM-336, Enables You to Start the
Triple-Play Services to a Small Scale Apartment Building.
No Additional Network Wiring is Necessary. You may just Use the
Existing Coax Wiring in the MDU Building, and be Ready to Provide
Broadband Services to Subscribers.
Low Initial Deployment Cost. Compare to the High Cost xDSL Solutions,
Suitable to Small Scale Building with Limited Subscribers.
Via the RJ-45 Ethernet Ports, Connect the MDU Master with Broadband
Access Devices such as Fiber Media Converter and ADSL/Cable Modem.
Remote Management Function Help to Ease the Support. |
|
- Coax Port as Distribution Backbone by Using Existing Coaxial Cable
- Two 10/100M Fast Ethernet Ports for FTTx, ADSL/Cable Modem
- Distance up to 4000 Feet Over RG59 Cables
- Filter Built-in to Eliminate Noise from TV/Antenna
- Remote Web/Telnet/SNMP Configuration and Diagnosis
- Secured and Isolated Communication
- Provision/Denial of Service
- Recovery from Firmware Upgrade Failure
- Firmware Upgrade for End-Points(EP)
- QoS Priority and Mapping Support
|
|
 Network Standards
- HomePNA3.1 over Coaxial Cable
(HCNA)
- IEEE802.3
- IEEE802.3u
- IEEE802.3x
Connectors
- Ethernet : Two RJ-45 Ports
- HCNA : Two F-Type Female Coax Connectors.
One for HCNA, the Other for TV or Antenna.
Transmission Power/Spectrum
- 0 +/- 1 dBm, 4~20MHz or 12~28MHz
Transmission Speed/Distance
- Up to 128Mbps (112Mbps for 12~28MHz)
- Up to 4000 Feet(-176dBm/Hz Noise Floor)
Quality of Service
- Priority based on IEEE802.1p/IP TOS/Diffserv and TCP/UDP Port
- Quaranteed QoS based on HomePNA3.1 Parameterized QoS
Network Management
- Web/SNMP Configuration and Firmware Upgrade
- Recovery from Firmware Upgrade Failure
- Diagnosis of HCNA Interface
- Firmware Upgrade for End-Points(EP)
- Secured/Isolated Communication between End-Points(EP)
- Provision/Denial of Service
- Subscriber Host Number Control
Fast Ethernet Interface
- 10/100Mbps
- MDI/MDI-X Auto Crossover
DIP Switch
Reset Button
- Reset Device or Force to Factory Setting
Indicators
- "Power" LED
- "LAN1", "LAN2" LEDs for Ethernet
- "Link/Act", "SyncMode", "Diagnosis" LEDs for HCNA
Power Requirement
- External Power Supply : 5V DC
- Power Consumption < 4 Watt
EMI/EMC
- Comply with FCC Part15
- Comply with CE
Environmental Conditions
- Operating Temperature : 0ĒJ ~ 55ĒJ (32ĒK ~ 131ĒK)
- Storage Temperature : -10ĒJ ~ 65ĒJ (14ĒK ~ 149ĒK)
- Operating Humidity : 10% ~ 95%, Non-condensing
Physical Dimension
- 160mm (W) x 105mm (D) x 28mm (H)
Unit Weight
|
|
|
|
| |
|
|
|
| |
 |
|
Copyright ©SendTek Corporation. All rights reserved |
|
|
|
